Vehicle emissions control(Redirected from Emissions testing)
Types of emissionsEdit
- Hydrocarbons (HC) - A class of burned or partially burned fuel, hydrocarbons are toxins. Hydrocarbons are a major contributor to smog, which can be a major problem in urban areas. Prolonged exposure to hydrocarbons contributes to asthma, liver disease, lung disease, and cancer. Regulations governing hydrocarbons vary according to type of engine and jurisdiction; in some cases, "non-methane hydrocarbons" are regulated, while in other cases, "total hydrocarbons" are regulated. Technology for one application (to meet a non-methane hydrocarbon standard) may not be suitable for use in an application that has to meet a total hydrocarbon standard. Methane is not directly toxic, but is more difficult to break down in fuel vent lines and a charcoal canister is meant to collect and contain fuel vapors and route them either back to the fuel tank or, after the engine is started and warmed up, into the air intake to be burned in the engine.
- Carbon monoxide (CO) - A product of incomplete combustion, inhaled carbon monoxide reduces the blood's ability to carry oxygen; overexposure (carbon monoxide poisoning) may be fatal. (Carbon monoxide persistently binds to hemoglobin, the oxygen-carrying chemical in red blood cells, where oxygen (O2) would temporarily bind; the bonding of CO excludes O2 and also reduces the ability of the hemoglobin to release already-bound oxygen, on both counts rendering the red blood cells ineffective. Recovery is by the slow release of bound CO and the body's production of new hemoglobin—a healing process—so full recovery from moderate to severe [but nonfatal] CO poisoning takes hours or days. Removing a person from a CO-poisoned atmosphere to fresh air stops the injury but does not yield prompt recovery, unlike the case where a person is removing from an asphyxiating atmosphere [i.e. one deficient in oxygen]. Toxic effects delayed by days are also common.)
- NOx - Generated when nitrogen in the air reacts with oxygen at the high temperature and pressure inside the engine. NOx is a precursor to smog and acid rain. NOx is the sum of NO and NO2. NO2 is extremely reactive. NOx production is increased when an engine runs at its most efficient (i.e. hottest) operating point, so there tends to be a natural tradeoff between efficiency and control of NOx emissions.
- Particulate matter – Soot or smoke made up of particles in the micrometre size range: Particulate matter causes negative health effects, including but not limited to respiratory disease and cancer. Very fine particulate matter has been linked to cardiovascular disease.
- Sulfur oxide (SOx) - A general term for oxides of sulfur, which are emitted from motor vehicles burning fuel containing sulfur. Reducing the level of fuel sulfur reduces the level of Sulfur oxide emitted from the tailpipe.
- Volatile organic compounds (VOCs) - Organic compounds which typically have a boiling point less than or equal to 250 °C; for example chlorofluorocarbons (CFCs) and formaldehyde. Volatile organic compounds are a subsection of Hydrocarbons that are mentioned separately because of their dangers to public health.
This article needs additional citations for verification. (November 2010) (Learn how and when to remove this template message)
Throughout the 1950s and 1960s, various federal, state and local governments in the United States conducted studies into the numerous sources of air pollution. These studies ultimately attributed a significant portion of air pollution to the automobile, and concluded air pollution is not bounded by local political boundaries. At that time, such minimal emission control regulations as existed in the U.S. were promulgated at the municipal or, occasionally, the state level. The ineffective local regulations were gradually supplanted by more comprehensive state and federal regulations. By 1967 the State of California created the California Air Resources Board, and in 1970, the federal United States Environmental Protection Agency (EPA) was established. Both agencies, as well as other state agencies, now create and enforce emission regulations for automobiles in the United States. Similar agencies and regulations were contemporaneously developed and implemented in Canada, Western Europe, Australia, and Japan.
The first effort at controlling pollution from automobiles was the PCV (positive crankcase ventilation) system. This draws crankcase fumes heavy in unburned hydrocarbons — a precursor to photochemical smog — into the engine's intake tract so they are burned rather than released unburned from the crankcase into the atmosphere. Positive crankcase ventilation was first installed on a widespread basis by law on all new 1961-model cars first sold in California. The following year, New York required it. By 1964, most new cars sold in the U.S. were so equipped, and PCV quickly became standard equipment on all vehicles worldwide.
The first legislated exhaust (tailpipe) emission standards were promulgated by the State of California for 1966 model year for cars sold in that state, followed by the United States as a whole in model year 1968. Also in 1966, the first emission test cycle was enacted in the State of California measuring tailpipe emissions in PPM (parts per million). The standards were progressively tightened year by year, as mandated by the EPA.
By the 1974 model year, the emission standards had tightened such that the de-tuning techniques used to meet them were seriously reducing engine efficiency and thus increasing fuel usage. The new emission standards for 1975 model year, as well as the increase in fuel usage, forced the invention of the catalytic converter for after-treatment of the exhaust gas. This was not possible with existing leaded gasoline, because the lead residue contaminated the platinum catalyst. In 1972, General Motors proposed to the American Petroleum Institute the elimination of leaded fuels for 1975 and later model year cars. The production and distribution of unleaded fuel was a major challenge, but it was completed successfully in time for the 1975 model year cars. All modern cars are now equipped with catalytic converters, and leaded fuel is no longer sold at filling stations in most First World countries. Leaded racing fuel is available in small quantities from some suppliers, but it is legal for off-road use only.
The agencies charged with implementing exhaust emission standards vary from jurisdiction to jurisdiction, even in the same country. For example, in the United States, overall responsibility belongs to the EPA, but due to special requirements of the State of California, emissions in California are regulated by the Air Resources Board. In Texas, the Texas Railroad Commission is responsible for regulating emissions from LPG-fueled rich burn engines (but not gasoline-fueled rich burn engines).
- California Air Resources Board - California, United States (most sources)
- Environment Canada - Canada (most sources)
- Environmental Protection Agency - United States (most sources)
- Texas Railroad Commission - Texas, United States (LPG-fueled engines only)
- Transport Canada - Canada (trains and ships)
The European Union has control over regulation of emissions in EU member states; however, many member states have their own government bodies to enforce and implement these regulations in their respective countries. In short, the EU forms the policy (by setting limits such as the European emission standard) and the member states decide how to best implement it in their own country.
In the United Kingdom, matters concerning environmental policy are what is known as "devolved powers" which means, each of the constituent countries deals with it separately through their own government bodies set up to deal with environmental issues in their respective country:
- Environment Agency - England and Wales
- Scottish Environment Protection Agency (SEPA) - Scotland
- Department of the Environment - Northern Ireland
However, many UK-wide policies are handled by the Department for Environment, Food and Rural Affairs (DEFRA) and they are still subject to EU regulations.
Advances in engine and vehicle technology continually reduce the toxicity of exhaust leaving the engine, but these alone have generally been proved insufficient to meet emissions goals. Therefore, technologies to detoxify the exhaust are an essential part of emissions control.
One of the first-developed exhaust emission control systems is secondary air injection. Originally, this system was used to inject air into the engine's exhaust ports to provide oxygen so unburned and partially burned hydrocarbons in the exhaust would finish burning. Air injection is now used to support the catalytic converter's oxidation reaction, and to reduce emissions when an engine is started from cold. After a cold start, an engine needs an air-fuel mixture richer than what it needs at operating temperature, and the catalytic converter does not function efficiently until it has reached its own operating temperature. The air injected upstream of the converter supports combustion in the exhaust headpipe, which speeds catalyst warmup and reduces the amount of unburned hydrocarbon emitted from the tailpipe.
Exhaust gas recirculationEdit
In the United States and Canada, many engines in 1973 and newer vehicles (1972 and newer in California) have a system that routes a metered amount of exhaust into the intake tract under particular operating conditions. Exhaust neither burns nor supports combustion, so it dilutes the air/fuel charge to reduce peak combustion chamber temperatures. This, in turn, reduces the formation of NOx.
The catalytic converter is a device placed in the exhaust pipe, which converts hydrocarbons, carbon monoxide, and NOx into less harmful gases by using a combination of platinum, palladium and rhodium as catalysts.
There are two types of catalytic converter, a two-way and a three-way converter. Two-way converters were common until the 1980s, when three-way converters replaced them on most automobile engines. See the catalytic converter article for further details.
Evaporative emissions controlEdit
Evaporative emissions are the result of gasoline vapors escaping from the vehicle's fuel system. Since 1971, all U.S. vehicles have had fully sealed fuel systems that do not vent directly to the atmosphere; mandates for systems of this type appeared contemporaneously in other jurisdictions. In a typical system, vapors from the fuel tank and carburetor bowl vent (on carbureted vehicles) are ducted to canisters containing activated carbon. The vapors are adsorbed within the canister, and during certain engine operational modes fresh air is drawn through the canister, pulling the vapor into the engine, where it burns.
Remote Sensing Emission testing – Field studiesEdit
Some US states are also using a technology developed by Dr. Donald H. Stedman of the University of Denver, which uses infra-red and ultraviolet light to detect emissions while vehicles pass by on public roads, thus eliminating the need for owners to go to a test center. Stedman's invisible light flash detection of exhaust gases is commonly used in metropolitan areas, is offered by the US-Swedish company OPUS Inspection and becoming more broadly known in Europe.
Use of emission test dataEdit
Emission test results from individual vehicles are in many cases compiled to evaluate the emissions performance of various classes of vehicles, the efficacy of the testing program and of various other emission-related regulations (such as changes to fuel formulations) and to model the effects of auto emissions on public health and the environment. For example, the Environmental Working Group used California ASM emissions data to create an "Auto Asthma Index" that rates vehicle models according to emissions of hydrocarbons and nitrogen oxides, chemical precursors to photochemical smog.
- AP 42 Compilation of Air Pollutant Emission Factors
- Emission standards
- Low carbon economy
- Motor vehicle emissions
- On-board diagnostics#OBD-I
- Onboard refueling vapor recovery
- Ontario's Drive Clean
- Portable Emissions Measurement System
- Roadway air dispersion modeling
- United States emission standards
- European emission standards
- Vehicle inspection
- EPA note on NO2 and health
- Rosen (Ed.), Erwin M. (1975). The Peterson automotive troubleshooting & repair manual. Grosset & Dunlap, Inc. ISBN 978-0-448-11946-5.CS1 maint: Extra text: authors list (link)
- "MOT diesel test not performed in NI for 12 years". BBC Northern Ireland News. Retrieved 26 September 2018.
- "Infrared Remote Sensing Of On-Road Motor Vehicle Emissions In Washington State" (PDF). (239 KB)
- "Opus Inspection » Remote Sensing Technology". opusinspection.com. Retrieved 2016-02-29.
- "Abgasmessungen RSD (Measuring pollutants by Remote Sensing in Zurich/Switzerland) by the Kanton's Office for Environmental Protection "awel" by means of equipment provided by Opus Inspection / etest". www.awel.zh.ch. Retrieved 2016-02-23.
- Manufacturers of Emission Controls Association (MECA)
- Emission Control Systems on FamilyCar.com
- National Vehicle and Fuel Emissions Laboratory of the United States Environmental Protection Agency
-  Mitchell 1 Emission Control Application Guide