In Euclidean geometry, a convex quadrilateral with at least one pair of parallel sides is referred to as a trapezium (//) in English outside North America, but as a trapezoid (//) in American and Canadian English. The parallel sides are called the bases of the trapezoid and the other two sides are called the legs or the lateral sides (if they are not parallel; otherwise there are two pairs of bases). A scalene trapezoid is a trapezoid with no sides of equal measure, in contrast to the special cases below.
Trapezoid or trapezium
|Edges and vertices||4|
The term trapezium has been in use in English since 1570, from Late Latin trapezium, from Greek τραπέζιον (trapézion), literally "a little table", a diminutive of τράπεζα (trápeza), "a table", itself from τετράς (tetrás), "four" + πέζα (péza), "a foot; end, border, edge".
The first recorded use of the Greek word translated trapezoid (τραπεζοειδή, trapezoeidé, "table-like") was by Marinus Proclus[dubious ] (412 to 485 AD) in his Commentary on the first book of Euclid's Elements.
This article uses the term trapezoid in the sense that is current in the United States and Canada. In many languages also using a word derived from the Greek, the form used is the one closest to trapezium, not to trapezoid (e.g. French trapèze, Italian trapezio, Portuguese trapézio, Spanish trapecio, German Trapez, Ukrainian "трапеція").
Trapezium vs TrapezoidEdit
The term trapezoid was once defined as a quadrilateral without any parallel sides in Britain and elsewhere. The Oxford English Dictionary (OED) says "Often called by English writers in the 19th century". According to the OED, the sense of a figure with no sides parallel is the meaning for which Proclus introduced the term "trapezoid". This is retained in the French trapézoïde, German Trapezoid, and in other languages. However, this particular sense is considered obsolete.
A trapezium in Proclus' sense is a quadrilateral having one pair of its opposite sides parallel. This was the specific sense in England in the 17th and 18th centuries, and again the prevalent one in recent use outside North America. A trapezium as any quadrilateral more general than a parallelogram is the sense of the term in Euclid.
Confusingly, the word trapezium was sometimes used in England from c. 1800 to c. 1875, to denote an irregular quadrilateral having no sides parallel. This is now obsolete in England, but continues in North America. However this shape is more usually (and less confusingly) just called an irregular quadrilateral.
Inclusive vs exclusive definitionEdit
There is some disagreement whether parallelograms, which have two pairs of parallel sides, should be regarded as trapezoids. Some define a trapezoid as a quadrilateral having only one pair of parallel sides (the exclusive definition), thereby excluding parallelograms. Others define a trapezoid as a quadrilateral with at least one pair of parallel sides (the inclusive definition), making the parallelogram a special type of trapezoid. The latter definition is consistent with its uses in higher mathematics such as calculus. This article uses the inclusive definition and considers parallelograms as special cases of a trapezoid. This is also advocated in the taxonomy of quadrilaterals.
Under the inclusive definition, all parallelograms (including rhombuses, rectangles and squares) are trapezoids. Rectangles have mirror symmetry on mid-edges; rhombuses have mirror symmetry on vertices, while squares have mirror symmetry on both mid-edges and vertices.
An acute trapezoid has two adjacent acute angles on its longer base edge, while an obtuse trapezoid has one acute and one obtuse angle on each base.
An isosceles trapezoid is a trapezoid where the base angles have the same measure. As a consequence the two legs are also of equal length and it has reflection symmetry. This is possible for acute trapezoids or right trapezoids (rectangles).
A parallelogram is a trapezoid with two pairs of parallel sides. A parallelogram has central 2-fold rotational symmetry (or point reflection symmetry). It is possible for obtuse trapezoids or right trapezoids (rectangles).
A Saccheri quadrilateral is similar to a trapezoid in the hyperbolic plane, with two adjacent right angles, while it is a rectangle in the Euclidean plane. A Lambert quadrilateral in the hyperbolic plane has 3 right angles.
Condition of existenceEdit
Four lengths a, c, b, d can constitute the consecutive sides of a non-parallelogram trapezoid with a and b parallel only when
Given a convex quadrilateral, the following properties are equivalent, and each implies that the quadrilateral is a trapezoid:
- It has two adjacent angles that are supplementary, that is, they add up to 180 degrees.
- The angle between a side and a diagonal is equal to the angle between the opposite side and the same diagonal.
- The diagonals cut each other in mutually the same ratio (this ratio is the same as that between the lengths of the parallel sides).
- The diagonals cut the quadrilateral into four triangles of which one opposite pair are similar.
- The diagonals cut the quadrilateral into four triangles of which one opposite pair have equal areas.:Prop.5
- The product of the areas of the two triangles formed by one diagonal equals the product of the areas of the two triangles formed by the other diagonal.:Thm.6
- The areas S and T of some two opposite triangles of the four triangles formed by the diagonals satisfy the equation
- where K is the area of the quadrilateral.:Thm.8
- The midpoints of two opposite sides and the intersection of the diagonals are collinear.:Thm.15
- The angles in the quadrilateral ABCD satisfy :p. 25
- The cosines of two adjacent angles sum to 0, as do the cosines of the other two angles.:p. 25
- The cotangents of two adjacent angles sum to 0, as do the cotangents of the other two adjacent angles.:p. 26
- One bimedian divides the quadrilateral into two quadrilaterals of equal areas.:p. 26
- Twice the length of the bimedian connecting the midpoints of two opposite sides equals the sum of the lengths of the other sides.:p. 31
Additionally, the following properties are equivalent, and each implies that opposite sides a and b are parallel:
- The consecutive sides a, c, b, d and the diagonals p, q satisfy the equation:Cor.11
- The distance v between the midpoints of the diagonals satisfies the equation:Thm.12
Midsegment and heightEdit
The midsegment (also called the median or midline) of a trapezoid is the segment that joins the midpoints of the legs. It is parallel to the bases. Its length m is equal to the average of the lengths of the bases a and b of the trapezoid,
The midsegment of a trapezoid is one of the two bimedians (the other bimedian divides the trapezoid into equal areas).
The height (or altitude) is the perpendicular distance between the bases. In the case that the two bases have different lengths (a ≠ b), the height of a trapezoid h can be determined by the length of its four sides using the formula
where c and d are the lengths of the legs.
The area K of a trapezoid is given by
where a and b are the lengths of the parallel sides, h is the height (the perpendicular distance between these sides), and m is the arithmetic mean of the lengths of the two parallel sides. In 499 AD Aryabhata, a great mathematician-astronomer from the classical age of Indian mathematics and Indian astronomy, used this method in the Aryabhatiya (section 2.8). This yields as a special case the well-known formula for the area of a triangle, by considering a triangle as a degenerate trapezoid in which one of the parallel sides has shrunk to a point.
The 7th-century Indian mathematician Bhāskara I derived the following formula for the area of a trapezoid with consecutive sides a, c, b, d:
When one of the parallel sides has shrunk to a point (say a = 0), this formula reduces to Heron's formula for the area of a triangle.
Another equivalent formula for the area, which more closely resembles Heron's formula, is
where is the semiperimeter of the trapezoid. (This formula is similar to Brahmagupta's formula, but it differs from it, in that a trapezoid might not be cyclic (inscribed in a circle). The formula is also a special case of Bretschneider's formula for a general quadrilateral).
From Bretschneider's formula, it follows that
The line that joins the midpoints of the parallel sides, bisects the area.
The lengths of the diagonals are
where a is the short base, b is the long base, and c and d are the trapezoid legs.
If the trapezoid is divided into four triangles by its diagonals AC and BD (as shown on the right), intersecting at O, then the area of AOD is equal to that of BOC, and the product of the areas of AOD and BOC is equal to that of AOB and COD. The ratio of the areas of each pair of adjacent triangles is the same as that between the lengths of the parallel sides.
Let the trapezoid have vertices A, B, C, and D in sequence and have parallel sides AB and DC. Let E be the intersection of the diagonals, and let F be on side DA and G be on side BC such that FEG is parallel to AB and CD. Then FG is the harmonic mean of AB and DC:
The line that goes through both the intersection point of the extended nonparallel sides and the intersection point of the diagonals, bisects each base.
The center of area divides this segment in the ratio (when taken from the short to the long side):p. 862
If the angle bisectors to angles A and B intersect at P, and the angle bisectors to angles C and D intersect at Q, then
In architecture the word is used to refer to symmetrical doors, windows, and buildings built wider at the base, tapering toward the top, in Egyptian style. If these have straight sides and sharp angular corners, their shapes are usually isosceles trapezoids. This was the standard style for the doors and windows of the Inca.
The crossed ladders problem is the problem of finding the distance between the parallel sides of a right trapezoid, given the diagonal lengths and the distance from the perpendicular leg to the diagonal intersection.
In morphology, taxonomy and other descriptive disciplines in which a term for such shapes is necessary, terms such as trapezoidal or trapeziform commonly are useful in descriptions of particular organs or forms.
In computer engineering, specifically digital logic and computer architecture, trapezoids are typically utilized to symbolize multiplexors. Multiplexors are logic elements that select between multiple elements and produce a single output based on a select signal. Typical designs will employ trapezoids without specifically stating they are multiplexors as they are universally equivalent.
- http://www.mathopenref.com/trapezoid.html Mathopenref definition
- A. D. Gardiner & C. J. Bradley, Plane Euclidean Geometry: Theory and Problems, UKMT, 2005, p. 34.
- Types of quadrilaterals
- πέζα is said to be the Doric and Arcadic form of πούς "foot", but recorded only in the sense "instep [of a human foot]", whence the meaning "edge, border". τράπεζα "table" is Homeric. Henry George Liddell, Robert Scott, Henry Stuart Jones, A Greek-English Lexicon, Oxford, Clarendon Press (1940), s.v. πέζα, τράπεζα.
- Oxford English Dictionary entry at trapezoid.[dead link]
- Oxford English Dictionary entries for trapezoid and trapezium.
- "Larousse definition for trapézoïde".
- Chambers 21st Century Dictionary Trapezoid
- "1913 American definition of trapezium". Merriam-Webster Online Dictionary. Retrieved 2007-12-10.
- "American School definition from "math.com"". Retrieved 2008-04-14.
- Weisstein, Eric W. "Trapezoid". MathWorld.
- Trapezoids, . Retrieved 2012-02-24.
- Ask Dr. Math (2008), "Area of Trapezoid Given Only the Side Lengths".
- Martin Josefsson, "Characterizations of trapezoids", Forum Geometricorum, 13 (2013) 23-35.
- T. K. Puttaswamy, Mathematical achievements of pre-modern Indian mathematicians, Elsevier, 2012, p. 156.
- GoGeometry, . Retrieved 2012-07-08.
- Owen Byer, Felix Lazebnik and Deirdre Smeltzer, Methods for Euclidean Geometry, Mathematical Association of America, 2010, p. 55.
- efunda, General Trapezoid, . Retrieved 2012-07-09.
- Tom M. Apostol and Mamikon A. Mnatsakanian (December 2004). "Figures Circumscribing Circles" (PDF). American Mathematical Monthly. 111 (10): 853–863. doi:10.2307/4145094. JSTOR 4145094. Retrieved 2016-04-06.
- "Machu Picchu Lost City of the Incas - Inca Geometry". gogeometry.com. Retrieved 2018-02-13.
- John L. Capinera (11 August 2008). Encyclopedia of Entomology. Springer Science & Business Media. pp. 386, 1062, 1247. ISBN 978-1-4020-6242-1.
- D. Fraivert, A. Sigler and M. Stupel : Common properties of trapezoids and convex quadrilaterals
- Trapezium at Encyclopedia of Mathematics.
- Weisstein, Eric W. "Right trapezoid". MathWorld.
- Trapezoid definition Area of a trapezoid Median of a trapezoid With interactive animations
- Trapezoid (North America) at elsy.at: Animated course (construction, circumference, area)
- Trapezoidal Rule on Numerical Methods for Stem Undergraduate
- Autar Kaw and E. Eric Kalu, Numerical Methods with Applications, (2008)