This article is within the scope of the Aviation WikiProject. If you would like to participate, please visit the project page, where you can join the project and see lists of open tasks and task forces. To use this banner, please see the full instructions.AviationWikipedia:WikiProject AviationTemplate:WikiProject Aviationaviation articles
This article has been checked against the following criteria for B-class status:
This article is within the scope of the Military history WikiProject. If you would like to participate, please visit the project page, where you can join the project and see a list of open tasks. To use this banner, please see the full instructions.Military historyWikipedia:WikiProject Military historyTemplate:WikiProject Military historymilitary history articles
This article has been checked against the following criteria for B-class status:
In the malfunction section, the dimensions of the screw do not match up. Should it be 10.2mm? 122.49.169.252 (talk) 07:30, 17 August 2010 (UTC)Reply
Thanks I have changed it to 10mm, although I am not sure it is correct a 10mm screw is very small, I suspect it should be 4 inches. A mistake of using 5in instead of 4in is much more likely. The whole section is referenced to a printed source so it is difficult to prove either way. MilborneOne (talk) 08:00, 17 August 2010 (UTC)Reply
4 inches is 101.6mm so rounded off that would be 102mm. I think you are right and it should be 5 and 4 inches. 122.49.169.252 (talk) 13:06, 18 August 2010 (UTC)Reply