Typical applications are in fixing a crank to its crankshaft, as in a bicycle, or a piston rod to a crosshead, as in a steam engine. Note: the angle of the wedge determines the position of the parts being held, therefore on a bicycle the pedal arms will only be at 180 degrees to each other if the angle of the cotter pin's wedge is the same on both pins.
Formerly, it was common to mount bicycle cranks using a cotter, though now usually a more easily maintained arrangement is used such as a square tapered or splined interface. These cotters have a short threaded section at the narrower end of the taper, which is used to hold the cotter in place with a washer and nut.
- Van der Plas, Rob (1993), The Bicycle Repair Book: The New Complete Manual of Bicycle Care (2nd ed.), MBI Publishing Company, p. 66, ISBN 978-0-933201-55-2.