Mbam Stanley

How to Lock any “file and folder” without any software

How to Lock any “file and folder” without any software 🔐🔒🔓👉🏻📁🖥💻 by.STANLEY

Lock Folder

You are looking to protect your file or folder any how any cost, don’t worry, in this article I’m going to show you how locks any file or folder using without any software. Here I will show you how to protect your file or folder, just follow these simple steps below:

At first open notepad by using “win-key + R”, that means open run and type notepad into the box and press enter or open any text editor. Then copy & paste the following code below and save it “ .bat ” file extension, example for “lock.bat”, whereas the lock is given name and .bat is the file extension. Then go to your save location and double click to run it, now you should see a command prompt where need a password to open the locker. Your passwordis “mypassword”, you can change your password any time when you want to change.

Step-1:

Open notepad or any text editor.

Blank Notepad

Step-2:

Copy this code:

cls

End

@ECHO OFF title Folder Locker if EXIST "Control Panel.{21EC2020-3AEA-1069-A2DD-08002B30309D}" goto UNLOCK if NOT EXIST Locker goto MDLOCKER

CONFIRM

echo Are you sure u want to Lock the folder(Y/N) set/p "cho=>" if %cho%==Y goto LOCK if %cho%==y goto LOCK if %cho%==n goto END if %cho%==N goto END echo Invalid choice. goto CONFIRM

LOCK

ren Locker "Control Panel.{21EC2020-3AEA-1069-A2DD-08002B30309D}" attrib +h +s "Control Panel.{21EC2020-3AEA-1069-A2DD-08002B30309D}" echo Folder locked goto End

UNLOCK

echo Enter password to Unlock folder set/p "pass=>" if NOT %pass%==mypassword goto FAIL attrib -h -s "Control Panel.{21EC2020-3AEA-1069-A2DD-08002B30309D}" ren "Control Panel.{21EC2020-3AEA-1069-A2DD-08002B30309D}" Locker echo Folder Unlocked successfully goto End

FAIL

echo Invalid password goto end

MDLOCKER

md Locker echo Locker created successfully goto End

Step-3:

Paste into the notepad

Paste

Step-4:

Save it lock.bat extension

Lock.bat & Locker

Step-5:

Now go to your save location and double click to run your “ lock.bat ” file. Then open a command prompt window, here need for a password to unlock. Now you must see a “ Locker” folder on your save location. Your default Password is “mypassword”.

Changing Password

Note :-- If you want to change your password, then Right click your lock.bat file extension then click edit and find “mypassword” to change your password, then replace your password to “mypassword”. Example for any name, phone no. etc.

             You can create this locker in any drive or folder. Enjoy……
   By Stanley Mbam Stanley (talk) 07:55, 30 March 2018 (UTC)