Open main menu
Schematic diagram showing a built up edge.

In single point cutting of metals, a built up edge (BUE) is an accumulation of material against the rake face, that seizes to the tool tip, separating it from the chip.[1]

Contents

FormationEdit

Because shear is strongest at the contact surface with the cutting tool, the first layer of metal impacting and seizing on it work-hardens more than the rest of the volume of metal. As a consequence of this work hardening, this first layer of metal is stronger than the adjacent metal moving away from the workpiece. Effectively, said first layer becomes part of the tool. The process repeats itself and, after some time, a built up edge (which could be several hundred micrometres thick) forms.[1]

The conditions necessary for a noticeable edge to build up are that:

  • the cutting speed is low.[2] This is because at high cutting speeds the metal moving away from the workpiece becomes hot enough to recover before seizing onto the tool, preventing the formation of a BUE.[3]
  • the metal being cut is one that work-hardens and is reluctant to recover (in the stress-recovery sense).[2] A BUE will not form with pure metals since they do not work-harden much. Conversely, alloys, such as steel, do work-harden and recover less so they are prone to forming a BUE.[3]

Effects on the cutting processEdit

The built up edge effectively changes tool geometry and rake steepness. It also reduces the contact area between the chip and the cutting tool,[1] leading to:

  • A reduction in the power demand of the cutting operation.[1]
  • Slight increase in tool life, since the cutting is partly being done by the built up edge rather than the tool itself.[4]

However, the formation of BUEs have negative effects on the quality of the workpiece,[1] specifically:

  • Excessive work hardening at the surface of the workpiece.[1]
  • Poor surface finish, since bits of the BUE eventually break off and stick to the workpiece. These bits tend to be problematic since, due to the work-hardening they underwent, they are very hard and so become abrasive.[1]
  • A reduction in the dimensional control of the process, due to the dynamically changing geometry of the cutting tool.

See alsoEdit

ReferencesEdit

  1. ^ a b c d e f g The Open University (UK), 2001. T881 Manufacture Materials Design: Block 2: Cutting, page 14. Milton Keynes: The Open University.
  2. ^ a b The Open University (UK), 2001. T881 Manufacture Materials Design: Block 2: Cutting, page 14 and 15. Milton Keynes: The Open University.
  3. ^ a b The Open University (UK), 2001. T881 Manufacture Materials Design: Block 2: Cutting, page 15. Milton Keynes: The Open University.
  4. ^ Rao, P.N. (2009). Manufacturing Technology - 2, Metal cutting and Machine tools. New Delhi: Tata McGraw-Hill. pp. 9–11. ISBN 978-0-07-008769-9.