Block (periodic table)(Redirected from F-block)
A block of the periodic table of elements is a set of adjacent groups. The term appears to have been first used by Charles Janet. The respective highest-energy electrons in each element in a block belong to the same atomic orbital type. Each block is named after its characteristic orbital; thus, the blocks are:
- g-block (hypothetical)
The block names (s, p, d, f and g) are derived from the spectroscopic notation for the associated atomic orbitals: sharp, principal, diffuse and fundamental, and then g which follows f in the alphabet.
The following is the order for filling the "subshell" orbitals, according to the Aufbau principle, which also gives the linear order of the "blocks" (as atomic number increases) in the periodic table:
- 1s, 2s, 2p, 3s, 3p, 4s, 3d, 4p, 5s, 4d, 5p, 6s, 4f, 5d, 6p, 7s, 5f, 6d, 7p, ...
The "periodic" nature of the filling of orbitals, as well as emergence of the s, p, d and f "blocks" is more obvious, if this order of filling is given in matrix form, with increasing principal quantum numbers starting the new rows ("periods") in the matrix. Then, each subshell (composed of the first two quantum numbers) is repeated as many times as required for each pair of electrons it may contain. The result is a compressed periodic table, with each entry representing two successive elements:
1s 2s 2p 2p 2p 3s 3p 3p 3p 4s 3d 3d 3d 3d 3d 4p 4p 4p 5s 4d 4d 4d 4d 4d 5p 5p 5p 6s 4f 4f 4f 4f 4f 4f 4f 5d 5d 5d 5d 5d 6p 6p 6p 7s 5f 5f 5f 5f 5f 5f 5f 6d 6d 6d 6d 6d 7p 7p 7p
There is an approximate correspondence between this nomenclature of blocks, based on electronic configuration, and groupings of elements based on chemical properties. The s-block and p-block together are usually considered as the main group elements, the d-block corresponds to the transition metals, and the f-block are the lanthanides and the actinides. However, not everyone agrees on the exact membership of each set of elements, so that for example the group 12 elements Zn, Cd and Hg are considered as main group by some scientists and transition metals by others, because they are chemically and physically more similar to the p-block elements than the other d-block elements. Furthermore, the group 3 elements and the f-block are sometimes also considered main group elements due to their similarities to the s-block elements. Groups (columns) in the f-block (between groups 3 and 4) are not numbered.
Helium is coloured differently from the p-block elements surrounding it because is in the s-block, with its outer (and only) electrons in the 1s atomic orbital, although its chemical properties are more similar to the p-block noble gases due to its full shell. In addition to the blocks listed in this table, there is a hypothetical g-block which is not pictured here. The g-block elements can be seen in the expanded extended periodic table. Also, lanthanum and actinium are placed under scandium and yttrium to reflect their status as d-block elements, as they have no electrons in the 4f and 5f orbitals, respectively, while lutetium and lawrencium do.
The s-block is on the left side of the periodic table and includes elements from the first two columns, the alkali metals (group 1) and alkaline earth metals (group 2), plus helium. Helium is a controversial element for the scientists as it can be placed in the second group of s block as well as the 18th group of p-block, but most scientists consider it to rest at the top of group 18 i.e. above neon (atomic number 10) as it has many properties similar to the group 18 elements.
Most s-block elements are highly reactive metals due to the ease with which their outer s-orbital electrons interact to form compounds. The first period elements in this block, however, are nonmetals. Hydrogen is highly chemically reactive, like the other s-block elements, but helium is a virtually unreactive noble gas.
S-block elements are unified by the fact that their valence electrons (outermost electrons) are in the s orbital. The s-orbital is a single spherical cloud which can contain only one pair of electrons; hence, the s-block consists of only two columns in the periodic table. Elements in column 1, with a single s-orbital valence electron, are the most reactive of the block. Elements in the second column have two s-orbital valence electrons, and, except for helium, are only slightly less reactive.
The p-block is on the right side of the periodic table and includes elements from the six columns beginning with column 13 and ending with column 18. Helium, though being in the top of group 18, is not included in the p-block.
The p-block is home to the biggest variety of elements and is the only block that contains all three types of elements: metals, nonmetals, and metalloids. Generally, the p-block elements are best described in terms of element type or group.
P-block elements are unified by the fact that their valence electrons (outermost electrons) are in the p orbital. The p orbital consists of six lobed shapes coming off a central point at evenly spaced angles. The p orbital can hold a maximum of six electrons, hence there are six columns in the p-block. Elements in column 13, the first column of the p-block, have one p-orbital electron. Elements in column 14, the second column of the p-block, have two p-orbital electrons. The trend continues this way until we reach column 18, which has six p-orbital electrons.
P-block metals have classic metal characteristics: they are shiny, they are good conductors of heat and electricity, and they lose electrons easily. Generally, these metals have high melting points and readily react with nonmetals to form ionic compounds. Ionic compounds form when a positive metal ion bonds with a negative nonmetal ion.
Of the p-block metals, several have fascinating properties. Gallium, in the 3rd row of column 13, is a metal that can melt in the palm of a hand. Tin, in the fourth row of column 14, is an abundant, flexible, and extremely useful metal. It is an important component of many metal alloys like bronze, solder, and pewter.
Sitting right beneath tin is lead, a toxic metal. Ancient people used lead for a variety of things, from food sweeteners to pottery glazes to eating utensils. It has been suspected that lead poisoning is related to the fall of Roman civilization, but further research has shown this to be unlikely. For a long time, lead was used in the manufacturing of paints. It was only within the last century that lead paint use has been restricted due to its toxic nature.
Metalloids have properties of both metals and nonmetals, but the term 'metalloid' lacks a strict definition. All of the elements that are commonly recognized as metalloids are in the p-block: boron, silicon, germanium, arsenic, antimony, and tellurium. Metalloids tend to have lower electrical conductivity than metals, yet often higher than nonmetals. They tend to form chemical bonds similarly to nonmetals, but may dissolve in metallic alloys without covalent or ionic bonding. Metalloid additives can improve properties of metallic alloys, sometimes paradoxically to their own apparent properties. Some may give a better electrical conductivity, higher corrosion resistance, ductility, or fluidity in molten state, etc. to the alloy.
Boron has many carbon-like properties, but is very rare. It has many uses, for example a P type semiconductor dopant.
Silicon is perhaps the most famous metalloid. It is the second most abundant element in Earth's crust and one of the main ingredients in glass. It is used to make semiconductor circuits, from large power switches and high current diodes to microchips for computers and other electronic devices. It is also used in certain metallic alloys, e.g. to improve casting properties of alumimium. So valuable is silicon to the technology industry that Silicon Valley in California is named after it.
Germanium has properties very similar to silicon, yet this element is much more rare. It was once used for its semiconductor properties pretty much as silicon is now, and it has some superior properties at that, but is now a rare material in the industry.
Arsenic is a toxic metalloid that has been used throughout history as an additive to metal alloys, paints, and even makeup.
Antimony is used as a constituent in casting alloys such as printing metal.
- Not always considered as metalloids:
- Carbon, in the same column with silicon and germanium, electrically fairly conductive unlike most other nonmetals, and to an extent preferred as a trace constituent in certain metallic alloys such as steel
- Phosphorus has metallurgical uses among others, e.g. a constituent of some copper alloys
- Selenium, once used as a semiconductor material, and also used to improve properties of metallic alloys
- Aluminium is generally considered a metal, but it has some metalloid/non-metal properties such as negative oxidation states
Previously called inert gases, their name was changed as there are a few other gases that are inert but not noble gases, such as nitrogen. The noble gases are located in the far right column of the periodic table, also known as Group Zero or Group Eighteen. Noble gases are also called as aerogens but this nomenclature of the group is not officially accepted by the IUPAC.
All of the noble gases have full outer shells with eight electrons. However, at the top of the noble gases is helium, with a shell that is full with only two electrons. The fact that their outer shells are full means they rarely react with other elements, which led to their original title of "inert."
Because of their chemical properties, these gases are also used in the laboratory to help stabilize reactions that would usually proceed too quickly. As the atomic numbers increase, the elements become rarer. They are not just rare in nature, but rare as useful elements, too.
- Helium is best known for its low density, used to safely produce buoyancy for zeppelins and balloons
- Neon is notorious as the red to yellow glow medium of old low power signal lamps and signs
- Argon is used as a protective gas in MIG and TIG welding
- Xenon is used as a plasma medium in high intensity arc lamps with tungsten electrodes. Automotive xenon lights, however, are mostly mercury vapor bulbs with low pressure xenon to help striking the arc and producing light instantly.
- Krypton has many uses like arc flash medium. Krypton filled incandescent bulbs were once the most efficient variety, before being replaced by halogen technology.
- Radon is radioactive, and one of the densest elements to remain in gas state at room temperature
The second column from the right side of the periodic table, group 17, is the halogen family of elements. These elements are all just one electron shy of having full shells. Because they are so close to being full, they have the trait of combining with many different elements and are very reactive. They are often found bonding with metals and elements from Group One, as these elements in each have one electron.
Not all halogens react with the same intensity. Fluorine is the most reactive and combines with most elements from around the periodic table. As with other columns, reactivity decreases as the atomic number increases.
The d-block is on the middle of the periodic table and includes elements from columns 3 through 12. These elements are also known as the transition metals because they show a transitivity in their properties i.e. they show a trend in their properties in simple incomplete d orbitals. Transition basically means d orbital lies between s and p orbitals and shows a transition from properties of s to p.
The d-block elements are all metals which exhibit two or more ways of forming chemical bonds. Because there is a relatively small difference in the energy of the different d-orbital electrons, the number of electrons participating in chemical bonding can vary. This results in the same element exhibiting two or more oxidation states, which determines the type and number of its nearest neighbors in chemical compounds.
D-block elements are unified by having in their outermost electrons one or more d-orbital electrons but no p-orbital electrons. The d-orbitals can contain up to five pairs of electrons; hence, the block includes ten columns in the periodic table.
The f-block is in the center-left of a 32-column periodic table but in the footnoted appendage of 18-column tables. These elements are not generally considered as part of any group. They are often called inner transition metals because they provide a transition between the s-block and d-block in the 6th and 7th row (period), in the same way that the d-block transition metals provide a transitional bridge between the s-block and p-block in the 4th and 5th rows.
The known f-block elements come in two series, the lanthanides of period 6 and the radioactive actinides of period 7. All are metals. Because the f-orbital electrons are less active in determining the chemistry of these elements, their chemical properties are mostly determined by outer s-orbital electrons. Consequently, there is much less chemical variability within the f-block than within the s-, p-, or d-blocks.
F-block elements are unified by having one or more of their outermost electrons in the f-orbital but none in the d-orbital or p-orbital. The f-orbitals can contain up to seven pairs of electrons; hence, the block includes fourteen columns in the periodic table.
The g-block is a hypothetical block of elements in the extended periodic table whose outermost electrons are posited to have one or more g-orbital electrons but no f-, d- or p-orbital electrons.
- Charles Janet, La classification hélicoïdale des éléments chimiques, Beauvais, 1928
- Lavelle, Laurence. "Lanthanum (La) and Actinium (Ac) Should Remain in the d-Block" (PDF). lavelle.chem.ucla.edu. Retrieved 9 November 2014.
- Wilford, John Noble (17 March 1983). "ROMAN EMPIRE'S FALL IS LINKED WITH GOUT AND LEAD POISONING". The New York Times. Retrieved 19 January 2016.
- Killgrove, Kristina (20 January 2012). "Lead Poisoning in Rome - The Skeletal Evidence". Powered by Osteons. Retrieved 19 January 2016.
- Sumner, Thomas (21 April 2014). "Did Lead Poisoning Bring Down Ancient Rome?". Science Magazine. Retrieved 19 January 2016.