DPPH is a common abbreviation for the organic chemical compound 2,2-diphenyl-1-picrylhydrazyl. It is a dark-colored crystalline powder composed of stable free radical molecules. DPPH has two major applications, both in laboratory research: one is a monitor of chemical reactions involving radicals, most notably it is a common antioxidant assay,[1] and another is a standard of the position and intensity of electron paramagnetic resonance signals.

DPPH
Skeletal formula of DPPH
sample
Names
Preferred IUPAC name
2,2-Diphenyl-1-(2,4,6-trinitrophenyl)hydrazin-1-yl
Other names
2,2-Diphenyl-1-picrylhydrazyl
1,1-Diphenyl-2-picrylhydrazyl radical
2,2-Diphenyl-1-(2,4,6-trinitrophenyl)hydrazyl
Diphenylpicrylhydrazyl
Identifiers
3D model (JSmol)
Abbreviations DPPH
ChemSpider
ECHA InfoCard 100.015.993 Edit this at Wikidata
UNII
  • InChI=1S/C18H12N5O6/c24-21(25)15-11-16(22(26)27)18(17(12-15)23(28)29)19-20(13-7-3-1-4-8-13)14-9-5-2-6-10-14/h1-12H checkY
    Key: HHEAADYXPMHMCT-UHFFFAOYSA-N checkY
  • InChI=1/C18H13N5O6/c24-21(25)15-11-16(22(26)27)18(17(12-15)23(28)29)19-20(13-7-3-1-4-8-13)14-9-5-2-6-10-14/h1-12,19H
    Key: WCBPJVKVIMMEQC-UHFFFAOYAG
  • InChI=1/C18H12N5O6/c24-21(25)15-11-16(22(26)27)18(17(12-15)23(28)29)19-20(13-7-3-1-4-8-13)14-9-5-2-6-10-14/h1-12H
    Key: HHEAADYXPMHMCT-UHFFFAOYAG
  • c1ccc(cc1)N(c2ccccc2)[N]c3c(cc(cc3[N+](=O)[O-])[N+](=O)[O-])[N+](=O)[O-]
Properties
C18H12N5O6
Molar mass 394.32 g/mol
Appearance Black to green powder, purple in solution
Density 1.4 g/cm3
Melting point 135 °C (275 °F; 408 K) (decomposes)
insoluble
Solubility in methanol 10 mg/mL
Hazards
NFPA 704 (fire diamond)
NFPA 704 four-colored diamondHealth 0: Exposure under fire conditions would offer no hazard beyond that of ordinary combustible material. E.g. sodium chlorideFlammability 1: Must be pre-heated before ignition can occur. Flash point over 93 °C (200 °F). E.g. canola oilInstability 0: Normally stable, even under fire exposure conditions, and is not reactive with water. E.g. liquid nitrogenSpecial hazards (white): no code
0
1
0
Safety data sheet (SDS) MSDS
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
checkY verify (what is checkY☒N ?)

Properties and applications

edit

DPPH has several crystalline forms which differ by the lattice symmetry and melting point. The commercial powder is a mixture of phases which melts at ~130 °C. DPPH-I (m.p. 106 °C) is orthorhombic, DPPH-II (m.p. 137 °C) is amorphous and DPPH-III (m.p. 128–129 °C) is triclinic.[2]

DPPH is a well-known radical and a trap ("scavenger") for other radicals. Therefore, rate reduction of a chemical reaction upon addition of DPPH is used as an indicator of the radical nature of that reaction. Because of a strong absorption band centered at about 520 nm, the DPPH radical has a deep violet color in solution, and it becomes colorless or pale yellow when neutralized. This property allows visual monitoring of the reaction, and the number of initial radicals can be counted from the change in the optical absorption at 520 nm or in the EPR signal of the DPPH.[3]

 

Because DPPH is an efficient radical trap, it is also a strong inhibitor of radical-mediated polymerization.[4]

 
Inhibition of polymer chain, R, by DPPH.

As a stable and well-characterized solid radical source, DPPH is the traditional and perhaps the most popular standard of the position (g-marker) and intensity of electron paramagnetic resonance (EPR) signals – the number of radicals for a freshly prepared sample can be determined by weighing and the EPR splitting factor for DPPH is calibrated at g = 2.0036. DPPH signal is convenient by that it is normally concentrated in a single line, whose intensity increases linearly with the square root of microwave power in the wider power range. The dilute nature of the DPPH radicals (one unpaired spin per 41 atoms) results in a relatively small linewidth (1.5–4.7 G). The linewidth may however increase if solvent molecules remain in the crystal and if measurements are performed with a high-frequency EPR setup (~200 GHz), where the slight g-anisotropy of DPPH becomes detectable.[5][6]

Whereas DPPH is normally a paramagnetic solid, it transforms into an antiferromagnetic state upon cooling to very low temperatures of the order 0.3 K. This phenomenon was first reported by Alexander Prokhorov in 1963.[7][8][9][10]

References

edit
  1. ^ Sharma, Om P.; Bhat, Tej K. (15 April 2009). "DPPH antioxidant assay revisited". Journal of Food Chemistry. 113 (4): 1202–1205. doi:10.1016/j.foodchem.2008.08.008.
  2. ^ Kiers, C. T.; De Boer, J. L.; Olthof, R.; Spek, A. L. (1976). "The crystal structure of a 2,2-diphenyl-1-picrylhydrazyl (DPPH) modification". Acta Crystallographica Section B. 32 (8): 2297. doi:10.1107/S0567740876007632.
  3. ^ Alger, Mark S. M. (1997). Polymer science dictionary. Springer. p. 152. ISBN 0-412-60870-7.
  4. ^ Cowie, J. M. G.; Arrighi, Valeria (2008). Polymers: Chemistry and Physics of Modern Materials (3rd ed.). Scotland: CRC Press. ISBN 978-0-8493-9813-1.
  5. ^ M.J. Davies (2000). Electron Paramagnetic Resonance. Royal Society of Chemistry. p. 178. ISBN 0-85404-310-1.
  6. ^ Charles P. Poole (1996). Electron spin resonance: a comprehensive treatise on experimental techniques. Courier Dover Publications. p. 443. ISBN 0-486-69444-5.
  7. ^ A. M. Prokhorov and V.B. Fedorov, Soviet Phys. JETP 16 (1963) 1489.
  8. ^ Fujito, Teruaki (1981). "Magnetic Interaction in Solvent-free DPPH and DPPH–Solvent Complexes". Bulletin of the Chemical Society of Japan. 54 (10): 3110. doi:10.1246/bcsj.54.3110.
  9. ^ Lundqvist, Stig (1998). "A. M. Prokhorov". Nobel Lectures in Physics, 1963–1970. World Scientific. p. 118. ISBN 981-02-3404-X.
  10. ^ Aleksandr M. Prokhorov, The Nobel Prize in Physics 1964