The Szyszkowski Equation[1] has been used by Meissner and Michaels[2] to describe the decrease in surface tension of aqueous solutions of carboxylic acids, alcohols and esters at varying mole fractions. It describes the exponential decrease of the surface tension at low concentrations reasonably but should be used only at concentrations below 1 mole%.[3]

Equation

edit
 

with:

  • σm is surface tension of the mixture
  • σw is surface tension of pure water
  • a is component specific constant (see table below)
  • x is mole fraction of the solvated component

The equation can be rearranged to be explicit in a:

 

This allows the direct calculation of that component specific parameter a from experimental data.

The equation can also be written as:

 

with:

  • γ is surface tension of the mixture
  • γ0 is surface tension of pure water
  • R is ideal gas constant 8.31 J/(mol*K)
  • T is temperature in K
  • ω is cross-sectional area of the surfactant molecules at the surface

The surface tension of pure water is dependent on temperature. At room temperature (298 K), it is equal to 71.97 mN/m [4]

Parameters

edit

Meissner and Michaels published the following a constants:

Szyszkowski Equation Constants
Compound a.104 Compound a.104
Propionic acid 26 n-Propyl alcohol 26
Isopropyl alcohol 26 Methyl acetate 26
n-Propyl amine 19 Methyl ethyl ketone 19
n-Butyric acid 7 Isobutyric acid 7
n-Butyl alcohol 7 Isobutyl alcohol 7
Propyl formate 8.5 Ethyl acetate 8.5
Methyl propionate 8.5 Diethyl ketone 8.5
Ethyl propionate 3.1 Propyl acetate 3.1
n-Valeric acid 1.7 Isovaleric acid 1.7
n-Amyl alcohol 1.7 Isoamyl alcohol 1.7
Propyl propionate 1.0 n-Caproic acid 0.75
n-Heptanoic acid 0.17 n-Octanoic acid 0.034
n-Decanoic acid 0.0025

Example

edit

The following table and diagram show experimentally determined surface tensions in the mixture of water and propionic acid.

Surface Tension of Propionic Acid solved in Water[5]
xAcid [mol/mol] xWater [mol/mol] σ [mN/m] T [K] a.104
1(Pure Acid) 0 26.68 293.15 298.
0.18229 0.81771 33.08 293.15 90.7
0.17102 0.82898 33.15 293.15 85.6
0.1494 0.8506 33.54 293.15 77.2
0.12803 0.87197 34.18 293.15 69.7
0.10947 0.89053 34.56 293.15 61.4
0.0869 0.9131 35.3 293.15 51.8
0.0747 0.9253 35.77 293.15 46.3
0.06602 0.93398 36.43 293.15 43.2
0.05436 0.94564 38.51 293.15 42.2
0.0455 0.9545 40.07 293.15 40.3
0.03268 0.96732 42.34 293.15 35.1
0.02075 0.97925 46.78 293.15 32.8
0.01457 0.98543 50.17 293.15 31.4
0.00861 0.99139 53.61 293.15 25.9
0 1(Pure Water) 72.58 293.15
    

This example shows a good agreement between the published value a=2.6*10−3 and the calculated value a=2.59*10−3 at the smallest given mole fraction of 0.00861 but at higher concentrations of propionic acid the value of an increases considerably, showing deviations from the predicted value.

See also

edit

References

edit
  1. ^ B. von Szyszkowski, Z. physik. Chemie, 64, 385 (1908)
  2. ^ H.P. Meissner, A.S. Michaels, Surface Tension s of Pure Liquids and Liquid Mixtures", Ind. Eng. Chem., 41(12), 2782, (1949)
  3. ^ Bruce E. Poling, John M. Prausnitz, John P. O’Connell, The Properties of Gases and Liquids, 5th Edition
  4. ^ NIST Chemistry WebBook http://webbook.nist.gov/chemistry/
  5. ^ Suarez F., Romero C.M., J.Chem.Eng.Data, 56(5), 1778-1786, 2011