The IBM 1443 Printer (sometimes referred to as the 1443 Flying Type Bar Printer[1]) is an obsolete computer line printer used in the punched card era. It was offered in three models: Models 1, 2 and N1; the last two could print up to 240 lines per minute (LPM) with a full character set.[2][3][4]

IBM 1443 exposed in the IBM 1460 presentation stand

The 1443 was initially introduced October 11, 1962 for use with the IBM 1440 system and withdrawn February 8, 1971.[5] It was announced in 1963 for the 1620 system. The printer could also be used on the IBM 1620[2] (announced 1963[6]), IBM 1710,[2] IBM 1800[7] and System/360.[3]

Decades later IBM recycled the 1443 model number to refer to a different product.[8][failed verification]

Back side of IBM 1443 printer

1443 printing capabilities

edit

The IBM 1443 Printer was introduced as part of the IBM 1440 system.[9] The 1443 Model 1 prints alphanumeric, upper-case only, output at a basic rate of 150 lines per minute, and it can print up to 430 lines a minute with a restricted character set, depending upon the type bars used. The Model 2's and Model N1's corresponding speeds are 240 and 600 LPM.[3]

The typebars[9] are easily interchangeable, with options for character sets containing 13, 39, 52,[10] or 63 characters.

The print speeds vary according to the model and the character set.[2][3][11]

Character set size Model 1 Model 2 Model N1
13 430 600 600
39 190 300 300
52 150 240 240
63 120 - 200

The 1443 printer uses 120 or 144 print hammers and hammer magnets,[12] conceptually similar to the IBM 1132 printer's one-per-column print magnets.

Output is formatted at 10 characters per inch, with a choice of six or eight lines per inch,[2]: p.1  with additional options for single, double or triple-spacing.[2]: p.3 

The 1443 uses fan-folded paper with perforated edges for tractor feeding. A carriage control tape specifies form length and the form line where printing was to begin so that paper of various sizes could be used. A carriage control tape simplifies use of pre-printed forms and the programming needed to allow proper alignment.[2]: p.3 

Successor technology

edit

Type bars were replaced by type wheels or a drum in later printers, most notably:

The 1132 was the last printer manufactured by IBM to use the 407's technology. In 1959 this technology was superseded with the introduction of the IBM 1403 chain printer;[15] both the 1132 and 1403 were available with the 1130.

See also

edit

Photos

edit

References

edit
  1. ^ "1443 Flying Type Bar Printer".
  2. ^ a b c d e f g "IBM 1443 PRINTER for 1620/1710 Systems" (PDF). IBM Systems Reference Library.
  3. ^ a b c d IBM System/360 System Summary (PDF) (0 ed.). IBM. 1964. p. 31. Retrieved 12 May 2022.
  4. ^ IBM System/360 System Summary (PDF) (12 ed.). IBM. 1974. p. 7-1. Retrieved 12 May 2022.
  5. ^ IBM Corporation. "1440 Data Processing System". IBM Archives. Archived from the original on January 14, 2005. Retrieved 2022-05-19.
  6. ^ "DPD chronology". IBM Archives. Archived from the original on August 20, 2010. Retrieved 2022-05-19.
  7. ^ IBM 1800 Data Acquisition and Control System: System Summary (PDF). IBM Systems Reference Library (1st ed.). IBM Corporation. p. 10. Retrieved 20 May 2022.
  8. ^ "Printer Ribbon IBM 1443 Texas Instruments Omni 800 RP-594". Archived from the original on 2017-12-22. Retrieved 2017-12-19.
  9. ^ a b "1440 Data Processing System". Archived from the original on January 14, 2005.
  10. ^ "A-Z upper case, 10 digits 0-9, and 16 special characters: "Executive Guide to the IBM 1440 Data Processing System" (PDF). 1962.
  11. ^ IBM 1440 System Component Description... (PDF). IBM Systems Reference Library (0th ed.). IBM Corporation. 1962. p. 18. Retrieved 20 May 2022.
  12. ^ depending on whether the printer has the standard 120 columns or the optional 144-columns
  13. ^ "IBM 407 accounting machine". Archived from the original on January 1, 2007.
  14. ^ "IBM 1130 Functional Characteristics" (PDF).
  15. ^ "How the IBM 1403 printer hammered out 1100 lines per minute".