Spent nuclear fuel
Spent nuclear fuel, occasionally called used nuclear fuel, is nuclear fuel that has been irradiated in a nuclear reactor (usually at a nuclear power plant). It is no longer useful in sustaining a nuclear reaction in an ordinary thermal reactor and depending on its point along the nuclear fuel cycle, it may have considerably different isotopic constituents.
- 1 Nature of spent fuel
- 2 Spent fuel decay heat
- 3 Fuel composition and long term radioactivity
- 4 Spent fuel corrosion
- 5 Storage, treatment, and disposal
- 6 Risks
- 7 See also
- 8 References
Nature of spent fuelEdit
See Large, John H: Radioactive Decay Characteristics of Irradiated Nuclear Fuels, January 2006.
In the oxide fuel, intense temperature gradients exist that cause fission products to migrate. The zirconium tends to move to the centre of the fuel pellet where the temperature is highest, while the lower-boiling fission products move to the edge of the pellet. The pellet is likely to contain lots of small bubble-like pores that form during use; the fission product xenon migrates to these voids. Some of this xenon will then decay to form caesium, hence many of these bubbles contain a large concentration of 137Cs.
In the case of mixed oxide (MOX) fuel, the xenon tends to diffuse out of the plutonium-rich areas of the fuel, and it is then trapped in the surrounding uranium dioxide. The neodymium tends to not be mobile.
Also metallic particles of an alloy of Mo-Tc-Ru-Pd tend to form in the fuel. Other solids form at the boundary between the uranium dioxide grains, but the majority of the fission products remain in the uranium dioxide as solid solutions. A paper describing a method of making a non-radioactive "uranium active" simulation of spent oxide fuel exists.
3% of the mass consists of fission products of 235U and 239Pu (also indirect products in the decay chain); these are considered radioactive waste or may be separated further for various industrial and medical uses. The fission products include every element from zinc through to the lanthanides; much of the fission yield is concentrated in two peaks, one in the second transition row (Zr, Mo, Tc, Ru, Rh, Pd, Ag) and the other later in the periodic table (I, Xe, Cs, Ba, La, Ce, Nd). Many of the fission products are either non-radioactive or only short-lived radioisotopes. But a considerable number are medium to long-lived radioisotopes such as 90Sr, 137Cs, 99Tc and 129I. Research has been conducted by several different countries into segregating the rare isotopes in fission waste including the "fission platinoids" (Ru, Rh, Pd) and silver (Ag) as a way of offsetting the cost of reprocessing; this is not currently being done commercially.
The fission products can modify the thermal properties of the uranium dioxide; the lanthanide oxides tend to lower the thermal conductivity of the fuel, while the metallic nanoparticles slightly increase the thermal conductivity of the fuel.
Table of chemical dataEdit
|Tc Ru Rh Pd Ag Cd In Sb||-||Yes||-||-|
|La Ce Pr Nd Pm Sm Eu||-||-||-||Yes|
About 1% of the mass is 239Pu and 240Pu resulting from conversion of 238U, which may be considered either as a useful byproduct, or as dangerous and inconvenient waste. One of the main concerns regarding nuclear proliferation is to prevent this plutonium from being used by states, other than those already established as nuclear weapons states, to produce nuclear weapons. If the reactor has been used normally, the plutonium is reactor-grade, not weapons-grade: it contains more than 19% 240Pu and less than 80% 239Pu, which makes it not ideal for making bombs. If the irradiation period has been short then the plutonium is weapons-grade (more than 93%).
96% of the mass is the remaining uranium: most of the original 238U and a little 235U. Usually 235U would be less than 0.83% of the mass along with 0.4% 236U.
If using a thorium fuel to produce fissile U-233, the SNF (Spent Nuclear Fuel) will have U-233, with a half-life of 159,200 years (unless this uranium is removed from the spent fuel by a chemical process). The presence of U-233 will affect the long-term radioactive decay of the spent fuel. If compared with MOX fuel, the activity around one million years in the cycles with thorium will be higher due to the presence of the not fully decayed U-233.
For natural uranium fuel: Fissile component starts at 0.71% 235U concentration in natural uranium. At discharge, total fissile component is still 0.50% (0.23% 235U, 0.27% fissile 239Pu, 241Pu) Fuel is discharged not because fissile material is fully used-up, but because the neutron-absorbing fission products have built up and the fuel becomes significantly less able to sustain a nuclear reaction.
Traces of the minor actinides are present in spent reactor fuel. These are actinides other than uranium and plutonium and include neptunium, americium and curium. The amount formed depends greatly upon the nature of the fuel used and the conditions under which it was used. For instance, the use of MOX fuel (239Pu in a 238U matrix) is likely to lead to the production of more 241Am and heavier nuclides than a uranium/thorium based fuel (233U in a 232Th matrix).
Spent fuel decay heatEdit
When a nuclear reactor has been shut down and the nuclear fission chain reaction has ceased, a significant amount of heat will still be produced in the fuel due to the beta decay of fission products. For this reason, at the moment of reactor shutdown, decay heat will be about 7% of the previous core power if the reactor has had a long and steady power history. About 1 hour after shutdown, the decay heat will be about 1.5% of the previous core power. After a day, the decay heat falls to 0.4%, and after a week it will be 0.2%. The decay heat production rate will continue to slowly decrease over time.
Spent fuel that has been removed from a reactor is ordinarily stored in a water-filled spent fuel pool for a year or more (in some sites 10 to 20 years) in order to cool it and provide shielding from its radioactivity. Practical spent fuel pool designs generally do not rely on passive cooling but rather require that the water be actively pumped through heat exchangers.
Fuel composition and long term radioactivityEdit
The use of different fuels in nuclear reactors results in different SNF composition, with varying activity curves.
Long-lived radioactive waste from the back end of the fuel cycle is especially relevant when designing a complete waste management plan for SNF. When looking at long-term radioactive decay, the actinides in the SNF have a significant influence due to their characteristically long half-lives. Depending on what a nuclear reactor is fueled with, the actinide composition in the SNF will be different.
An example of this effect is the use of nuclear fuels with thorium. Th-232 is a fertile material that can undergo a neutron capture reaction and two beta minus decays, resulting in the production of fissile U-233. Its radioactive decay will strongly influence the long-term activity curve of the SNF around a million years. A comparison of the activity associated to U-233 for three different SNF types can be seen in the figure on the top right. The burnt fuels are Thorium with Reactor-Grade Plutonium (RGPu), Thorium with Weapons-Grade Plutonium (WGPu) and Mixed Oxide fuel (MOX, no thorium). For RGPu and WGPu, the initial amount of U-233 and its decay around a million years can be seen. This has an effect in the total activity curve of the three fuel types. The initial absence of U-233 and its daughter products in the MOX fuel results in a lower activity in region 3 of the figure on the bottom right, whereas for RGPu and WGPu the curve is maintained higher due to the presence of U-233 that has not fully decayed. Nuclear reprocessing can remove the actinides from the spent fuel so they can be used or destroyed (see Long-lived fission product#Actinides).
Spent fuel corrosionEdit
Noble metal nanoparticles and hydrogenEdit
According to the work of corrosion electrochemist David W. Shoesmith, the nanoparticles of Mo-Tc-Ru-Pd have a strong effect on the corrosion of uranium dioxide fuel. For instance his work suggests that when hydrogen (H2) concentration is high (due to the anaerobic corrosion of the steel waste can), the oxidation of hydrogen at the nanoparticles will exert a protective effect on the uranium dioxide. This effect can be thought of as an example of protection by a sacrificial anode, where instead of a metal anode reacting and dissolving it is the hydrogen gas that is consumed.
Storage, treatment, and disposalEdit
Spent nuclear fuel is stored either in spent fuel pools (SFPs) or in dry casks. In the United States, SFPs and casks containing spent fuel are located either directly on nuclear power plant sites or on Independent Spent Fuel Storage Installations (ISFSIs). ISFSIs can be adjacent to a nuclear power plant site, or may reside elsewhere. The vast majority of ISFSIs store spent fuel in dry casks. The Morris Operation is currently the only ISFSI with a spent fuel pool in the United States.
Nuclear reprocessing can separate spent fuel into various combinations of reprocessed uranium, plutonium, minor actinides, fission products, remnants of zirconium or steel cladding, activation products, and the reagents or solidifiers introduced in the reprocessing itself. If these constituent portions of spent fuel were reused, and additional wastes that may come as a byproduct of reprocessing are limited, reprocessing could ultimately reduce the volume of waste that needs to be disposed.
Alternatively, the intact spent nuclear fuel can be directly disposed of as high-level radioactive waste. The United States has planned disposal in deep geological formations, such as the Yucca Mountain nuclear waste repository, where it has to be shielded and packaged to prevent its migration to humans' immediate environment for thousands of years. On March 5, 2009, however, Energy Secretary Steven Chu told a Senate hearing that "the Yucca Mountain site no longer was viewed as an option for storing reactor waste."
In the rare occurrence of a fuel failure during normal operation, the primary coolant can enter the element. Visual techniques are normally used for the postirradiation inspection of fuel bundles.
Since the September 11 attacks the Nuclear Regulatory Commission has instituted a series of rules mandating that all fuel pools be impervious to natural disaster and terrorist attack. As a result, used fuel pools are encased in a steel liner and thick concrete, and are regularly inspected to ensure resilience to earthquakes, tornadoes, hurricanes, and seiches.
-  Testimony of Robert Meyers Principal deputy Assistant Administrator for the Office of Air and Radiation U.S. Environmental Protection Agency before the subcommittee on Energy and Air Quality Committee on Energy and Commerce U. S. House of Representatives, July 15, 2008
- Lucuta, P.G.; Verrall, R.A.; Matzke, Hj.; Palmer, B.J. (January 1991). "Microstructural features of SIMFUEL — Simulated high-burnup UO2-based nuclear fuel". Journal of Nuclear Materials. 178 (1): 48–60. doi:10.1016/0022-3115(91)90455-G.
- Dong-Joo Kim, Jae-Ho Yang, Jong-Hun Kim, Young-Woo Rhee, Ki-Won Kang, Keon-Sik Kim and Kun-Woo Song, Thermochimica Acta, 2007, 455, 123–128.
- "Solution of Fission Products in UO2" (PDF). Archived from the original (PDF) on 2008-09-10. Retrieved 2008-05-18.
- "RWMAC's Advice to Ministers on the Radioactive Waste Implications of Reprocessing". Radioactive Waste Management Advisory Committee (RWMAC). 3 November 2002. Archived from the original on 29 August 2008. Retrieved 2008-05-18.
- "David W. Shoesmith". University of Western Ontario. Retrieved 2008-05-18.
- "Electrochemistry and corrosion studies at Western". Shoesmith research group, University of Western Ontario. Retrieved 2008-05-18.
- Hebert, H. Josef. "Nuclear waste won't be going to Nevada's Yucca Mountain, Obama official says". Chicago Tribune. Archived from the original on 2011-03-24.
- Ialenti, Vincent (October 2017). "Death and succession among Finland's nuclear waste experts". Physics Today. 70 (10): 48–53. Bibcode:2017PhT....70j..48I. doi:10.1063/PT.3.3728.
- Parenti, Christian (March 15, 2011). "Fukushima's Spent Fuel Rods Pose Grave Danger". The Nation.
- "Are Nuclear Spent Fuel Pools Secure?". Council on Foreign Relations. June 7, 2003. Archived from the original on 2011-04-12. Retrieved 2011-04-05.
- Benjamin, Mark (March 23, 2011). "How Safe Is Nuclear-Fuel Storage in the U.S.?". Time Magazine.
- Huang, W. H.; Krause, T. W.; Lewis, B. J. (10 April 2017). "Laboratory Tests of an Ultrasonic Inspection Technique to Identify Defective CANDU Fuel Elements". Nuclear Technology. 176 (3): 452–461. doi:10.13182/NT11-A13320.
- "Fact Sheet on Storage of Spent Nuclear Fuel". Archived from the original on 2014-10-27. Retrieved 2017-06-25.
- "Nuclear Waste Disposal". Archived from the original on 2012-07-06. Retrieved 2012-06-05.