Open main menu

Wikipedia β

Pressure reference system

  (Redirected from Pressure Reference System)

Pressure reference system (PRS) is an enhancement of the inertial reference system and attitude and heading reference system designed to provide position angles measurements which are stable in time and does not suffer by long term drift caused by the sensors imperfections.[1] The measurement system uses behavior of the International Standard Atmosphere where atmospheric pressure descends with increasing altitude and two pairs of measurement units. Each pair measures pressure at two different positions that are mechanically connected with known distance between units, e.g. the units are mounted at the tips of the wing. In the horizontal flight, there is no pressure difference measured by the measurement system which means the position angle is zero. In case the airplane turns the tips of the wing mutually changes their position, one is going up and the second one is going down, and the pressure sensors in every unit measure different values which are translated into a position angle.

Pressure Reference System entry points


The strapdown inertial navigation system uses double integration of the accelerations measured by an inertial measurement unit (IMU).[2] This process sums the sensors outputs together with all the sensor and measurement errors. The precision and long-term stability of the INS system depends on the quality of sensors used within the IMU. The sensor quality can be evaluated by Allan Variance technique. A precise IMU uses laser gyroscopes and precise accelerometers which are expensive. The INS is a sole system with no other inputs. Nowadays the trend of the modern navigation is to integrate [3] signals from IMU together with data provided by Global Positioning System (GPS). This approach gives long term stability to the INS output by suppressing sensor error influence on the calculation of the airplane position. The measurement system becomes attitude and heading reference system which can relax requirement on the sensor precision because the long-term stability is assured by GPS. The sensors used within AHRS are used only for position angles determination and so just one numerical integration of the angular rate measurements is required. The AHRS system is cheaper and a lot of universities and companies are developing AHRS systems based on microelectromechanical systems (MEMS) sensors. The MEMS sensors do not have performance required for navigation purposes. It is shown in an experimental research report,[4] where the output of the navigation solution drifts away after 2 seconds. The AHRS units based on MEMS inertial sensors usually also use a vector magnetometer, a GPS receiver, and a data fusion algorithm to cope with MEMS inertial sensors errors. Next to the sensor imperfections there are also environmental parameters which influence the computed values (position angles):

  • temperature effects (and humidity, pressure, etc.)
  • engine vibrations
  • accelerations caused by airplane movement, e.g. turns
  • etc.[5]

All these influences cause drifts in the computed output data which can confuse pilot who performs the flight.

Pressure reference systemEdit

The concept of the PRS was defined by Pavel Paces in his PhD thesis[6] where results measured under laboratory conditions were also published. Three arrangements of the PRS were evaluated:

  • central sensor/sensors[7]
  • distributed sensors with separate volumes
  • distributed sensors with a reference volume[8]

While the first method gives only ambiguous results the second method works well as it can be replaced by two altimeters. Disadvantage of the second method is high measurement uncertainty of both values. This is being solved by the extension of the reference volumes used even in absolute pressure sensors.[8]


  1. ^ King, A. D. (1998). "Inertial Navigation – Forty Years of Evolution" (PDF). GEC Review (General Electric Company plc). 13 (3): 140–149. Retrieved 2013-03-03. 
  2. ^ Stovall, Sherryl H. (September 1997). "Basic Inertial Navigation" (PDF). Naval Air Warfare Center Weapons Division. Retrieved 31 December 2012. 
  3. ^ Weed, D.; Broderick, J.; Love, J.; Ryno, T. (2004). GPS Align In Motion of civilian strapdown INS. Position Location and Navigation Symposium. 26–29 April 2004. pp. 184–192. doi:10.1109/PLANS.2004.1308992. Retrieved 31 December 2012. 
  4. ^ (Crittenden, Jordan; Evans, Parker (2008-05-08). "MEMS Inertial Navigation System" (PDF). Retrieved 2012-12-31. )
  5. ^ "MGL Avionics. SP-2 Magnetometer. SP-4 AHRS. User and Installation Manual" (PDF). MGL Avionics. Retrieved 31 December 2012. 
  6. ^ Paces, Pavel. "Improvement of the Flight Safety of UltraLight Category of Airplanes by the Avionics System Support" (PDF) (in Czech). Czech Technical University in Prague. Retrieved 31 December 2012. 
  7. ^ Paces, Pavel; Popelka, Jan; Levora, Tomas (2012). "Advanced Display And Position Angles Measurement Systems" (PDF). 28th International Congress of the Aeronautical Sciences. 
  8. ^ a b Paces, Pavel; Popelka, Jan (2012). IMU aiding using two AHRS units. Digital Avionics Systems Conference (DASC), 2012 IEEE/AIAA 31st. 14–18 October 2012. pp. 5B1–1–5B1–13. doi:10.1109/DASC.2012.6382359.