This article includes a list of general references, but it lacks sufficient corresponding inline citations. (March 2013) |
The boa knot[1][2][3][4] is a modern binding knot invented by weaver Peter Collingwood in 1996. His intention was to develop a knot that would hold well when the constricted object was cut close to the winds of the knot.
| Boa knot | |
|---|---|
.jpg) | |
| Category | Binding |
| Origin | Peter Collingwood in 1996 |
| Related | strangle knot, double constrictor knot |
| Typical use | Best used for securing objects in cylindrical loads |
The boa knot is related to the strangle knot and the double constrictor knot. It combines both the structure and qualities of these other two knots. The boa knot can be very difficult to untie and is inappropriate when frequent or fast untying is needed. The knotted part needs to lie over a convex surface to hold.
The boa knot is best used for securing objects in cylindrical loads. Said knot is hard to move around.
Tying edit
-
Start with making a loop counter-clockwise -
Place another loop in the same direction over the first loop -
Twist these loops, by turning the right side in clockwise direccion, so you get a figure-eight -
Take a cylindrical object and place it from under above in the first loops -
Then put the object through the other loops -
Pull the loose ends away from it, carefully shaping the knot. Make sure that the strands lined up as at the start. So they shouldn't slip out. -
This should tighten the loops to the point where they cling firmly to the desired object, yielding the boa knot. (Frontside) -
Boa-knot. (Backside)
Alternative edit
See also edit
References edit
- ^ Handbook of Knots by Des Pawson — ISBN 1-4053-0467-7
- ^ Knots — Andrew Adamides — ISBN 978-0-572-03329-3
- ^ The Complete Guide to Knots and Knot Tying — Geoffrey Budworth — p.164 — ISBN 0-7548-0422-4
- ^ Knotting Matters — issue 55 — p19