||This article needs additional citations for verification. (December 2009)|
In bus advertising, buses and their related infrastructure is a medium commonly used by advertisers to reach the public with their message. Usually, this takes the form of promoting commercial brands, but can also be used for public campaign messages. Buses may also be used as part of a political or promotional campaign, or as a tool in a commercial enterprise.
Bus advertising descends from similar methods used on streetcars in the early 20th century.
Adverts are placed in bus shelters. These can be static posters, or back illuminated displays, or rolling displays allowing many messages on one shelter. Technology has also been used to create interactive adverts.
Adverts may also be installed on associated street furniture such as the backs of benches at stops.
A common location for adverts is inside the bus. Adverts are attached to the corners between the walls and ceiling overhead to catch the eye of passengers, in the same manner as used in rapid transit systems.
Increasingly, companies are using interior television systems to advertise.
Adverts are often placed as basic rectangular motifs on the side or front of a bus. These may be applied directly to the bus. Additionally, adverts may be printed on placards known as boards, which are slotted into special guide fittings attached to the side of the bus.
Partial and full adverts
Occasionally, the entire surface of a bus is turned into an advertisement. This can be a whole side or rear of a bus, or a scheme applied to the entire exterior, known as an 'all-over advert' bus.
Some panel and full side and all-over adverts were traditionally painted on if the length of application warranted it. This would require a reasonable longevity and cost implication for advertisers, due to the requirement to take buses out of service to apply and remove paint schemes. Frequently changed panel adverts would use replaceable boards.
The introduction of perforated and directionally transparent vinyl sheets allowed the creation of more elaborate designs that could be applied over windows (although for safety reasons not the front window), moving away from the traditional square box design approach to adverts.
With the advent of partially transparent window coverage techniques, all over adverts have been applied as a full vehicle advertising wrap windows and all. The transition from screen printing to digital printing has seen an increase in the color range and complexity of advert designs.
Campaign and Promotion buses
In addition to public transport buses, all-over advert buses are often privately hired specifically for a special promotional use, such as a political campaign or specific product promotions. These will often make use of open top buses to allow the interaction of the campaigners/promoters with the public.
In Norway, the use of wrap advertising on buses was prohibited by the road authorities. The reason behind the ban was that in an emergency the windows might need to serve as an emergency exit, and that the advertising would make the window harder to break with the emergency hammer. Gaia Trafikk argued against the ban, pointing out that their tests showed that the thin wrap had no impact on the breakability of the window, but did remove the advertising which covered the windows.
|Wikimedia Commons has media related to: Buses with advertisement|
Read in another language
This page is available in 1 language